1. Plywood, 3.3 feet by 5 feet long
2. Plywood, 7½ inches wide, 29½ inches long
3. Plywood, 14 inches long and 4 inches widePlywood, 5½ inches long and 5½ inches wide with 2 notches 1 inch wide and ¼ inch from the edge (shown below)
4. Plywood, 10 ½ inches wide and 13 inches long
5. Plywood (cut angle about 25 degrees) (shown below)
6. Plywood (cut about 45 degrees) (shown below)
7. Plastic sheet, should be 4 feet wide and 6 feet long
8. 5 screws 1 inch long
9. 3/4 inch screws
10. 1/2 inch screws
11. 4 brass clamps
12. duct tape, electrical tape, hockey tape
13. shrink tube
14. 1 inch finishing nails
15. 2 electric leaf blowers
16. 2 Extension cords
17. Hole saw drill bit that is the same size as your 90 curved pipe
18. 90 degrees curved pipe that will fit the end of your leaf blower
19. Silicone
20. Paint
21. Spray paint
22. Paint primer
23. Thin wire
24. 2 staples
25. 52 inches of 3/4 inch steel shaft
26. Stop watch
27. Cement floor (should be about 30 feet long)
28. Pipe that will fit into the 90 degrees curve and into the deck, to make the blower level
29. Drill, skill saw, angle grinder, belt sander, die-grinder, utility knife, stapler, staples, screwdriver, tape measure, pencil, T-square, carpenters glue, hammer, 1/8 inch drill bit
