Battery Charger

Information

Results

The site that will explain you the way to build a complicated battery charger is:

http://www.angelfire.com/electronic/hayles/charge1.html

 
  1. We built the charger chip using the instructions on the site above and disassembled a normal battery charger and took out the light.
  2. We took two boards, made the needed holes for the cable and the switch and then we screwed the boards together.
  3. We put the on/off switch in the correct hole
  4. We took a the cable and plug and attached a part of it to the chip and the other to the switch.
  5. We have added on wires onto the chip so that it can go to distance.
  6. We attached screws, small tubes and a thing that changes sizes to fit in all kinds of batteries.

 

So now all you have to do is put the right wires to the correct terminals, plug it in and turn it on

 

 

Go to Results

       Next Page: Conclusion